Tools

CK1014-1 Pilot Hole Punch (w/2 needles)

An essential tape wiring installation tool, the Pilot Hole Punch provides a convenient method of making starter holes for brass brads at all electrical interconnection points. The diameter of the punching tip is smaller than the smallest brad used, thus...

MH40106 - Test Probe

Constructed with two sharp needles and a self-contained light bulb, the test probe can be used at any point along a conductive tape run for electrical testing or finding a tape run under wallpaper. Simply push the needles into the copper strips and, if...

CK1044-1 - Pins/Awl Replacement

Designed for use with Cir-Kit Concepts' CK1044 awl, CK1044-1 is a four pack of awl replacement pins that will store conveniently in the hollow compartment in the metal shank of the tool.

CK1044 - Awl

This tool has been designed specifically for placement of the CK1023 eyelet series. The awl is first used to make starter (or pilot) holes where eyelets are desired. The eyelet is then slipped over the awl insertion pin and pushed into place. It provides...

CR2S700 - BamBam

The spring tool, BamBam, simplifies the insertion of large grommets for dollhouse wiring! This tool eliminates the need for small brads or small grommets for tapewire connections. BamBam has a center punch on one end and a pin of the other designed to...

9V Tester w/Lead Clips

The perfect tester to keep in your dollhouse wiring toolbox. It is a simple unit using a 9-volt battery with two hooked clips. Great to see if the lamps and chandeliers you purchase really work before attempting to install them. Battery not included.

Plastic Layout Gauge

The plastic layout gauge is a quick way to mark and run tapewire. Simply use a pencil at one of the corners of the gauge and slide the gauge along the floor of the dollhouse making a line on the wall. Line up the top edge of the tapewire directly to the...