Cir-Kit Concepts

1/2 Amp Fuse

These fuses provide the high-speed action necessary to protect both transformer and lighting fixtures in the event of a short. They may be used as additional safety devices for new or existing...

Brass Slide-Switch Plate Cover

Discontinued, clearance priced.  Decorative brass switch plate cover for sliding switches.  

CK1002- 5' Tapewire Roll

5-foot tapewire roll for dollhouse wiring by Cir-Kit Concepts.  Double conductor tapewire first introduced in 1976 has been the predominant method of dollhouse wiring. Its use creates a...

CK1003 - Duplex Wall Outlet (receptacle)

To our knowledge, this is the smallest working outlet ever made, measuring a mere 13/32" high by 5/16" wide by 1/8" thick. The CK1003 outlet nails are embedded diagonally, allowing the outlet to be...

CK1003A - Duplex Outlet Cover

Give a polished brass look to all your one-inch (1:12) scale dollhouse miniature outlets. These bright and heavily engraved covers will provide a rich and finished appearance wherever they are used...

CK1004 - Electrical Plug

The "to scale" CK1004 plug is made to work with the CK1003 outlet and may be attached to the bulb wires from any lighting fixture. To make an electrical connection, stripped lamp wires are simply...

CK1004-3 - Male Plugs (6 pack)

Male plugs are packaged 6 per pack. Use these to create new lamps, rewire or replace old plugs on dollhouse lamps.  Substitute for MH658.  Use with pound-in receptacle...

CK1007 - Junction Splice

The CK1007 Junction Splice serves as the junction point for connecting the lead-in wire (from the transformer or power connector) to a tape run. The embedded nails, in addition to holding the...

CK1007-1 - Junction Splice Extender

If you wish to install your Junction Splice in a less conspicuous location, such as under the dollhouse, use this extender for easy electrical access. Simply plug it into the Junction splice (CK1007)...

CK1008-1 - Transformer Lead In Wire/Switch

CK1008-1 transformer lead-in wire with switch may be used for those installations requiring the convenience of total dollhouse on/off power control. (Eliminates need for unplugging lead-in wire from...

CK1008-3 - Lead-in Wire w/switch

This lead-in wire from Cir-Kit Concepts provides connection from a screw terminal type transformer to terminal block such as CK1049-3 used for electrifying a dollhouse, roombox, or diorama. Both ends...

CK1010-13 - Micro Bulb, Black Wire, 1.5 Volt

CK1010-13 is a micro bulb, 8" black wire, 1.5-volt from Cir-Kit Concepts