Electrical Components

CK1004 - Electrical Plug

The "to scale" CK1004 plug is made to work with the CK1003 outlet and may be attached to the bulb wires from any lighting fixture. To make an electrical connection, stripped lamp wires are simply inserted into small holes in the side of the plug and the...

CK1003A - Duplex Outlet Cover

Give a polished brass look to all your one-inch (1:12) scale dollhouse miniature outlets. These bright and heavily engraved covers will provide a rich and finished appearance wherever they are used. The double holes allow ample space for inserting and...

CK1003 - Duplex Wall Outlet (receptacle)

To our knowledge, this is the smallest working outlet ever made, measuring a mere 13/32" high by 5/16" wide by 1/8" thick. The CK1003 outlet nails are embedded diagonally, allowing the outlet to be mounted vertically regardless of whether the tape run is...

CK1002- 5' Tapewire Roll

5-foot tapewire roll for dollhouse wiring by Cir-Kit Concepts.  Double conductor tapewire first introduced in 1976 has been the predominant method of dollhouse wiring. Its use creates a printed circuit type layout. The tapewire has a strong...

CR2S908 - Snap On/Off Switch

This white snap on/off switch can be easily glued in place and is able to carry up to 1.5 amps of current. An excellent switch for working with LEDs. The overall size is just 1/2" by 5/16" and 5/16" high. The center button is just 3/16" in diameter.

CR2S907-2 - 1/16" Shrink Tubes

Package of 100 pieces of 1-3/4" long 1/16" shrink tube.  Tube can be heated with a match or a hair dryer to shrink it over bare wire junctions/connections.  Acts as an insulation jacket to protect two bare wires from shorting out.

3/32" Shrink Tubes

Ten 1-3/4" long pieces of 3/32" shrink tube. Tube can be heated with a match or a hair dryer to shrink it over bare wire junctions/connections. Acts as an insulation jacket to protect two bare wires from shorting out.

CR2S701-2 - Junction Strip

The junction strip is the second connector for people that prefer to use roundwire for dollhouse wiring. This unit has the same jack for the power supply plug and a fuse, but also an on/off toggle switch and a set of 12 connection blocks to wire...

1 to 2 Splitter

This electrical component is just what you need to easily run two displays from one power supply. Simply connect the single end to the output plug of the power supply then connect each of the two other cords into the separate plugs on each of the...

CR2S705-2 - Micro Jack (no tail)

Micro jacks make it possible to plug and unplug your light fixtures in the wiring system of your dollhouse when used in conjunction with Cir-Kit's sconce adapters (CK801), chandelier adapters (CK804 series), and plug-in ceiling plate (CK806).  These...

Micro Jacks w/Tails

Micro jacks make it possible to plug and unplug your light fixtures in the wiring system of your dollhouse when used in conjunction with Cir-Kit's sconce adapters (CK801), chandelier adapters (CK804 series), and plug-in ceiling plate (CK806). These micro...

CR2S701-0 - Mini Power Connector

A simple jack and connection block that replaces the junction splice. Simply press down the little red button, insert end of red connector wire (striped about 1/4" to expose silver wire) cut to a length to suit your needs into the corresponding hole...