Electrical Components

CK1033 - Green Heat Shrink Tubes

These small shrink tubes provide an excellent means of connecting 32-gauge wires such as GOW bulb wires together without the use of solder. The shrink tube is simply slid over one of the wires to be joined, the barred wires twisted together, and the...

CK1028-6 - Four-Pack Single Receptacles

CK1028-6 includes four single receptacle extension cords.  Each single unit receptacle features an approximate 8" length of white wire with plug allowing you to extend or hardwire an outlet into your tapewire system.  

1/2 Amp Fuse

These fuses provide the high-speed action necessary to protect both transformer and lighting fixtures in the event of a short. They may be used as additional safety devices for new or existing Cir-Kit Concepts' wiring installations.A blown fuse is easily...

CK1021-1 - 1/8" Brass Brads

This 60-count package of 1/8" brass brads are some of the smallest in the world. When folded corners in a tape run are not desired these small, precisely made brads provide a very unobtrusive and effective means of establishing electrical connection...

CK1017A - Tapewire, 50' Roll

The double conductor tapewire is the "heart" of all Cir-Kit wiring systems. From its introduction in 1976 to the present it has been the predominant method of dollhouse wiring. Its use creates a printed circuit type layout and completely eliminates the...

CK1010-7 - Screw Base Round Bulb

One round (pea), screw-base, 12-volt, replacement bulb by Cir-Kit Concepts.

CK1010-17B - 7/16" Candle Socket

CK1010-17B is a 7/16" candle socket with 12" varnished wires by Cir-Kit Concepts, Inc. This candle socket is great for replacing non-electrified light fixtures or creating your own. Use bi-pin bulbs such as CK1010-12, MH44013, or CR2S1010 or any of the...

CK1010-17 - 7/16" Candle Socket, White Wire

CK1010-17 is a 7/16" candle socket with 12" white wire that easily accommodates a flame tip bi-pin bulb. Create your own chandeliers or use these candle sockets to create a candle in your dollhouse windows. Just remember, you will need to drill holes...

CK1008-3 - Lead-in Wire w/switch

This lead-in wire from Cir-Kit Concepts provides connection from a screw terminal type transformer to terminal block such as CK1049-3 used for electrifying a dollhouse, roombox, or diorama. Both ends of CK1008-3 have spade lugs for connection between the...

CK1007-1 - Junction Splice Extender

If you wish to install your Junction Splice in a less conspicuous location, such as under the dollhouse, use this extender for easy electrical access. Simply plug it into the Junction splice (CK1007) and run the cord out for mating with the lead-in wire...

CK1004-3 - Male Plugs (6 pack)

Male plugs are packaged 6 per pack. Use these to create new lamps, rewire or replace old plugs on dollhouse lamps.  Substitute for MH658.  Use with pound-in receptacle (outlets) CK1003-1, MH776 or MH776X.   

CK1004 - Electrical Plug

The "to scale" CK1004 plug is made to work with the CK1003 outlet and may be attached to the bulb wires from any lighting fixture. To make an electrical connection, stripped lamp wires are simply inserted into small holes in the side of the plug and the...