Shop All

1" x 1/8" LED Ribbons (PW)

One of the easiest ways to install LEDs in your dollhouse or roombox miniature setting. Each package contains six pieces of 1" long by 1/8" wide ribbon. Each ribbon has two pure white LEDs, six-inch leads soldered to one end, and double stick tape on the...

CR2S610-1 - 1" x 1/8" LED Ribbons (WW)

One of the easiest ways to install LEDs to your dollhouse or miniature room setting. Each package contains six pieces of 1" long by 1/8" wide ribbon. Each piece has two warm white LEDs, six-inch leads soldered to one end, and double stick tape on the...

CR2S003 - Large Wiring Kit

Creative Reproduction 2 Scale's Large Wiring Kit includes everything you need to wire a dollhouse, diorama, or roombox with direct current (DC) power that allows you to electrify your project using any standard dollhouse miniature fixtures as well as...

CR2S001 - Basic Wiring Kit

Creative Reproduction 2 Scale's Basic Wiring Kit includes everything you need to wire a dollhouse, diorama, or roombox with direct current (DC) power which will allow you to electrify your project using any standard dollhouse miniature lamps as well as...

CR2S908 - Snap On/Off Switch

This white snap on/off switch can be easily glued in place and is able to carry up to 1.5 amps of current. An excellent switch for working with LEDs. The overall size is just 1/2" by 5/16" and 5/16" high. The center button is just 3/16" in diameter.

5 Meter LED Reel (CW)

These cool white LEDs on a reel are the least expensive way to purchase a length of lights. The approximately 1/4" wide ribbon has an adhesive backing making it very easy to install. These LEDs work with DC current only, so you will need to use a...

CR2S907-2 - 1/16" Shrink Tubes

Package of 100 pieces of 1-3/4" long 1/16" shrink tube.  Tube can be heated with a match or a hair dryer to shrink it over bare wire junctions/connections.  Acts as an insulation jacket to protect two bare wires from shorting out.

3/32" Shrink Tubes

Ten 1-3/4" long pieces of 3/32" shrink tube. Tube can be heated with a match or a hair dryer to shrink it over bare wire junctions/connections. Acts as an insulation jacket to protect two bare wires from shorting out.

CR2S701-2 - Junction Strip

The junction strip is the second connector for people that prefer to use roundwire for dollhouse wiring. This unit has the same jack for the power supply plug and a fuse, but also an on/off toggle switch and a set of 12 connection blocks to wire...

CR2S700 - BamBam

The spring tool, BamBam, simplifies the insertion of large grommets for dollhouse wiring! This tool eliminates the need for small brads or small grommets for tapewire connections. BamBam has a center punch on one end and a pin of the other designed to...

CR2S522-3 - Screwbase LED Candlesticks

Package of six pure white low intensity candlestick (candle body) replacement LED bulbs, each providing 50,000 hours 5 ma lighting.  Each new LED bulb is specially made to illuminate a full 360 degrees, looking very similar to the bulb it is...

CR2S522-1 - Screwbase LED Candlesticks

Package of 10 pure white high intensity candle stick replacement bulbs (50,000 hours, 30 ma). Now you can replace your old screw base bulbs with a 50,000 hour LED. These replacement bulbs are now available in a lower brightness level that is similar to...