CR2S

CR2S705-2 - Micro Jack (no tail)

Micro jacks make it possible to plug and unplug your light fixtures in the wiring system of your dollhouse when used in conjunction with Cir-Kit's sconce adapters (CK801), chandelier adapters (CK804...

CR2S707-1 - One-amp DC Power Supply

This 1 amp DC (direct current) power supply features 12-volt, voltage regulated circuits. This power supply will work with all of the lights you presently use and/or have installed, but will give you...

CR2S707-9 - One to Three Splitter

This cord is designed to power three different displays from one power supply.  It simply splits the output plug of the power supply into three separate plugs.  The wire cable has...

CR2S714 - Nine-Volt Battery Pack

Empty battery box made for the 9-volt battery. Box has an on/off slide switch and two 6-inch wire leads.  Connect wires for lights using shrink tubes.  

CR2S728-1 - 30' Flat Tapewire

A 30-foot roll of flat tapewire with a heavy Mylar coating. The tapewire has an adhesive backing that will adhere to most any surface. The two copper strips are colored black and copper for easy...

CR2S728-2 - 50' Flat Tapewire

50-foot roll of flat tapewire with a heavy mylar coating. The tapewire has an adhesive backing that will adhere to most any surface. The two copper strips are colored black and copper for easy...

CR2S729-2 - Subminiature Pin Connectors

Package of 4 small pin connectors with 8", 28 AWG Kynar wire leads on each end.  It is the perfect way to easily connect and disconnect a light or display module you wish to remove...

CR2S907-2 - 1/16" Shrink Tubes

Package of 100 pieces of 1-3/4" long 1/16" shrink tube.  Tube can be heated with a match or a hair dryer to shrink it over bare wire junctions/connections.  Acts as an insulation jacket to...

Landscape Spot Light

This new 12 volt LED landscape spot light features a blackish bronze, swivel base fixture that is perfect for illuminating trees or the front of your dollhouse. This particular unit works only with a...

Micro Jacks w/Tails

Micro jacks make it possible to plug and unplug your light fixtures in the wiring system of your dollhouse when used in conjunction with Cir-Kit's sconce adapters (CK801), chandelier adapters (CK804...

Plastic Layout Gauge

The plastic layout gauge is a quick way to mark and run tapewire. Simply use a pencil at one of the corners of the gauge and slide the gauge along the floor of the dollhouse making a line on the wall...

Pure White Can Lights

This light is the most realistic and best proportioned can light on the market. It uses a flat top pure white 5mm LED color. It is extremely easy to install. Simply drill a 5/16th inch hole in the...